Skip to content
Serving Brooklyn and nearby cities Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (447) 312-7370

Chimney Repair in Red Hook, Brooklyn

Serving Red Hook and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (447) 312-7370

The short answer

ProSweep Chimney Service repairs masonry chimneys, crowns, flashing, caps, dampers and flue liners in Red Hook, Brooklyn (11231). Every repair starts with an inspection, so you know what is wrong and what it will take to fix before any work begins.

Red Hook's rowhouses, small walk-ups and pre-war apartment buildings mostly have masonry chimneys that have been in service a long time. Over the years, mortar wears down, crowns crack, flashing pulls away from the roof and older flue liners deteriorate. Red Hook sits close to the water and takes plenty of wind and wet weather, which speeds up that wear. ProSweep Chimney Service repairs chimneys throughout ZIP code 11231. Red Hook is about a mile northwest of our Brooklyn office, so it is easy to set up an inspection or repair visit.

Common Chimney Repairs for Red Hook Homes

Most repair calls start with something a homeowner can see or smell. It might be water stains near the fireplace, bits of brick or mortar in the firebox, a damp smell in summer, or a chimney that looks like it is leaning. Our certified technicians inspect the chimney first. Then they explain what is causing the problem and what it will take to fix it.

  • Repointing: replacing cracked or missing mortar joints so water stops getting into the brick
  • Crown repair or rebuilding: fixing the cap of concrete or mortar on top of the chimney that sheds rain
  • Flashing repair: resealing the joint between the chimney and the roof, a common source of leaks on flat rowhouse roofs
  • Chimney caps: keeping out rain, debris, birds and other animals
  • Flue liner repair and relining: dealing with cracked clay tiles or worn-out liners
  • Damper and firebox repair: fixing stuck or rusted dampers, cracked firebrick and eroded mortar inside the fireplace

Why Older Brooklyn Masonry Needs Attention

Many chimneys in Red Hook and nearby Carroll Gardens, Cobble Hill and Gowanus were built with brick and soft, older mortar. When the mortar joints erode, water soaks into the brick. In winter that water freezes and expands. That can make the brick face flake or pop off (called spalling) and can loosen the crown. If nobody fixes it, small cracks turn into loose bricks, and eventually a section of the chimney has to be rebuilt.

Water also travels down into the house. A leaking chimney can stain ceilings and walls, rust the damper and weaken the flue liner. Fixing a crown or flashing early usually means a smaller job than repairing water damage inside the house later.

Oil-to-Gas Conversions and Flue Liners

When a New York City building converts its boiler from oil to gas, the chimney has to be evaluated as part of the work. A new liner is often needed. Gas exhaust produces acidic condensate, and that moisture can corrode a masonry flue that was built for oil.

Your building may be planning a conversion, or it may have already converted. If you are seeing white staining on the chimney, crumbling mortar or debris at the base of the flue, we can inspect it and tell you whether it needs a liner or other repairs. A new appliance or a switch of fuel is also one of the situations where the NFPA 211 standard calls for a Level 2 inspection.

Inspection First, Then Repair

The NFPA 211 standard calls for chimneys, fireplaces and vents to be inspected once a year. There are three levels: - A Level 1 inspection fits when nothing has changed. - A Level 2 inspection applies when the system changes, such as a new appliance or a switch of fuel, or when the home is sold. - A Level 3 inspection is used when a hidden hazard can only be reached by opening part of the chimney or building.

After the inspection, we walk you through what we found and show you photos when they help. We sort out what needs repair now and what can simply be watched. You get a written estimate before any repair work begins.

Planning Repairs Around Heat Season

New York City's heat season runs from October 1 through May 31. During those months, building owners must keep apartments heated to the city's minimum temperatures. If you own a multifamily building in Red Hook, a chimney problem that takes the boiler offline in winter is a serious issue. Late spring and summer are usually the easiest times to schedule masonry work, crown repairs and relining, so the system is ready before heat season starts.

Some problems should not wait for a convenient season. If you notice an active leak, falling brick or debris, or smoke coming into the house, stop using the fireplace or appliance and contact us for an inspection. Beyond Red Hook, we also repair chimneys in Park Slope and Brooklyn Heights.

More services in Red Hook

Related

What to expect

How a visit goes

  1. Inspect first

    We look at the whole system before suggesting anything, so recommendations are based on what we actually see in your chimney or vents.

  2. Show you the evidence

    We take photos of the flue, crown, damper or ductwork and walk you through them, so you can see the condition for yourself.

  3. Leave the house clean

    We lay down drop cloths, seal off the fireplace opening and use vacuums built for soot and debris, then clean up before we leave.

FAQ

Common questions

How do I know if my chimney needs repair?

Common signs include water stains near the fireplace or on nearby walls and ceilings, mortar or brick pieces in the firebox, gaps in the mortar joints, flaking brick, a cracked crown, and a damp or musty smell. An inspection will confirm what is going on.

Do I need an inspection before a repair?

Yes. We inspect the chimney first so the repair fixes the actual cause of the problem and not just the symptom. The NFPA 211 standard also calls for chimneys to be inspected once a year.

My building switched from oil to gas. Does the chimney need work?

It might. When a New York City building converts from oil to gas, the chimney has to be evaluated, and a new liner is often needed because gas exhaust produces acidic condensate that can corrode a masonry flue.

When is the best time to schedule chimney repairs?

Late spring and summer are usually easiest, before the city's heat season starts on October 1. Urgent problems such as active leaks, falling debris or smoke in the house should be checked right away, whatever the season.

Can a leaking chimney be fixed without rebuilding it?

Often, yes. Many leaks come from worn flashing, a cracked crown, a missing cap or eroded mortar joints, and those can usually be repaired. A full or partial rebuild is only needed when the masonry is too damaged to fix.

Which areas near Red Hook do you serve?

We serve all of ZIP code 11231 in Red Hook, plus Carroll Gardens, Cobble Hill, Gowanus, Park Slope and Brooklyn Heights.

Get Your Chimney or Vents Checked

Tell us what you're noticing, whether it's a smoky smell, a stain near the chimney or a dryer that won't dry. We'll inspect, show you photos and give you a written price before any work begins.

Call (447) 312-7370 Request Service