Skip to content
Serving Brooklyn and nearby cities Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (447) 312-7370

Chimney Repair in Brooklyn Heights, Brooklyn

Serving Brooklyn Heights and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (447) 312-7370

The short answer

Most chimney repairs in Brooklyn Heights involve worn mortar, cracked crowns, failed flashing or damaged flue liners in older brownstones, rowhouses and pre-war buildings. We inspect the chimney first, explain what needs fixing now and what can wait, and then repair the masonry or liner. Liner work is common when a building converts its boiler from oil to gas.

Chimney repair in Brooklyn Heights usually means working on older masonry that has carried smoke and exhaust for a long time. Many homes here are brownstones, rowhouses and pre-war apartment buildings with tall brick chimneys, shared party walls and flues that have served several heating systems over the years. ProSweep Chimney Service is based about 2 miles south in Brooklyn, and our certified technicians repair chimneys for homeowners and building owners across the neighborhood. This page explains what typically goes wrong, how we find it, and what a repair involves.

What tends to fail on Brooklyn Heights chimneys

Older masonry chimneys wear out from the top down and from the inside out. Weather hits the crown and upper brick first, while heat, moisture and exhaust work on the flue lining. Because many rowhouses share walls and rooflines with their neighbors, a chimney problem can also show up as a leak or stain in a spot that seems unrelated.

  • Cracked or crumbling mortar joints, especially near the top of the stack
  • A cracked or missing chimney crown that lets water into the masonry
  • Loose, rusted or missing chimney caps
  • Failed flashing where the chimney meets a flat or low-slope roof
  • Cracked, gapped or deteriorated clay flue tiles
  • Spalling brick, where the face flakes off after freeze-thaw cycles
  • A damper that no longer closes or seals

We inspect before we recommend a repair

The NFPA 211 standard calls for chimneys, fireplaces and vents to be inspected once a year, and a repair should start with the same kind of careful look. Chimney professionals use three inspection levels. A Level 1 inspection fits a chimney where nothing has changed. A Level 2 inspection applies when the system changes, such as a new appliance or a switch of fuel, or when the home is being sold. A Level 3 inspection is used only when a hidden hazard has to be reached by opening part of the chimney or building.

For most repairs, we examine the exterior masonry from the roof, check the crown and flashing, and look inside the flue. You get a plain explanation of what we found, what needs attention now and what can wait, so you can decide how to proceed.

Flue liners and oil-to-gas conversions

Many older Brooklyn Heights buildings have changed heating fuel at least once, and a move from oil to gas affects the chimney. When a New York City building converts its boiler from oil to gas, the chimney has to be evaluated as part of the work. A new liner is often needed, because gas exhaust produces acidic condensate that can corrode a masonry flue.

We also repair liners in chimneys that serve wood-burning fireplaces. Cracked clay tiles or open joints let heat and gases reach the surrounding brick and framing. Depending on the condition of the flue and the appliance it serves, the fix may be repairing the existing liner or installing a new one sized for the equipment.

Masonry, crowns, caps and flashing

On the outside of the chimney, most repairs come down to keeping water out. Water that soaks into brick and mortar freezes in winter, expands and breaks the masonry apart a little more each year. Common work includes repointing worn mortar joints, rebuilding the top courses of brick when they have loosened, repairing or replacing a cracked crown, and fitting a cap that keeps out rain, debris and animals.

Flashing gets special attention on rowhouses and apartment buildings with flat roofs, where water can pool against the base of the chimney. On older brick buildings, we aim to match the existing brick and mortar as closely as practical. If your building or co-op has its own approval process for exterior work, it helps to check those requirements before the job is scheduled.

Planning repairs around the heating season

New York City's heat season runs from October 1 through May 31, and during those months building owners must keep apartments heated to the city's minimum temperatures. In a multi-unit building, a repair that takes the boiler offline needs careful planning. Late spring and summer are usually the easiest times for liner work and larger masonry repairs.

If you notice a problem during the heating season, such as smoke or odors where they shouldn't be, water coming in near the chimney, or pieces of brick or tile falling, don't wait for warmer weather. Have the chimney looked at before you keep using it.

We also handle chimney repair in nearby Downtown Brooklyn, DUMBO, Boerum Hill, Carroll Gardens and Cobble Hill.

More services in Brooklyn Heights

Related

What to expect

How a visit goes

  1. Inspect first

    We look at the whole system before suggesting anything, so recommendations are based on what we actually see in your chimney or vents.

  2. Show you the evidence

    We take photos of the flue, crown, damper or ductwork and walk you through them, so you can see the condition for yourself.

  3. Leave the house clean

    We lay down drop cloths, seal off the fireplace opening and use vacuums built for soot and debris, then clean up before we leave.

FAQ

Common questions

How do I know if my chimney needs repair?

Common signs include crumbling mortar, flaking brick, water stains on walls or ceilings near the chimney, pieces of tile in the fireplace, a rusted or missing cap, and smoke or odors entering the room. An inspection confirms what is actually wrong.

Do I need a new liner if my building is switching from oil to gas?

Often, yes. In New York City the chimney has to be evaluated when a boiler converts from oil to gas, and a new liner is frequently needed because gas exhaust produces acidic condensate that can corrode a masonry flue.

How often should my chimney be inspected?

The NFPA 211 standard calls for chimneys, fireplaces and vents to be inspected once a year. A more detailed Level 2 inspection is appropriate when you change appliances or fuel, or when the home is sold.

When is the best time to schedule chimney repair in Brooklyn Heights?

Late spring and summer are usually easiest, especially for buildings with central boilers, since the city's heat season runs from October 1 through May 31. Safety problems should be addressed whenever they are found.

Can a chimney leak be fixed without rebuilding the chimney?

Many leaks come from a cracked crown, worn mortar joints, a missing cap or failed flashing, and these can usually be repaired without a full rebuild. Loose or badly damaged upper brick may need to be rebuilt.

Do you work on brownstones and pre-war apartment buildings?

Yes. Our certified technicians repair chimneys on brownstones, rowhouses, pre-war apartment buildings and other homes in Brooklyn Heights and nearby neighborhoods.

Get Your Chimney or Vents Checked

Tell us what you're noticing, whether it's a smoky smell, a stain near the chimney or a dryer that won't dry. We'll inspect, show you photos and give you a written price before any work begins.

Call (447) 312-7370 Request Service