Skip to content
Serving Brooklyn and nearby cities Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (447) 312-7370

Chimney Liner Installation in Gowanus, Brooklyn

Serving Gowanus and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (447) 312-7370

The short answer

Many older Gowanus chimneys need a new liner, especially after a boiler is converted from oil to gas or a new appliance is added. ProSweep inspects the flue, explains the findings, and installs a liner sized for the appliance it serves.

Many Gowanus homes have masonry chimneys that were never designed for the appliances now connected to them. A brownstone or rowhouse that once burned coal or oil may now vent a gas boiler, a modern water heater, or a wood stove, and each of these needs a flue sized and built for its exhaust. ProSweep Chimney Service installs chimney liners in Gowanus homes and small buildings in ZIP code 11231, about a mile northwest of our Brooklyn office. Our certified technicians inspect the flue first, explain what they find, and recommend a liner only when the chimney needs one.

Why Older Gowanus Chimneys Often Need a New Liner

Housing in Gowanus is a mix of rowhouses, brownstones, pre-war apartment buildings, and newer construction. Many older chimneys were built with no liner at all or with clay tile flues. Decades of heat, moisture, and freeze-thaw cycles can crack those tiles and wear away the mortar between them. Exhaust can then reach the brick and, in some cases, the inside of the house.

Fuel changes are a common trigger. When a New York City building converts its boiler from oil to gas, the chimney has to be evaluated as part of the work. A new liner is often needed because gas exhaust produces acidic condensate that can corrode a masonry flue. A flue that handled oil for years may not hold up once gas appliances start venting through it.

Signs Your Chimney May Need Relining

Some problems show up only during an inspection. Others you can notice yourself. Call us for a look if you see any of the following:

  • Flakes of tile, brick, or mortar collecting at the base of the flue or in the boiler cleanout
  • White staining or damp spots on chimney walls inside the house
  • A boiler or oil-to-gas conversion that is planned or recently finished
  • A new furnace, water heater, or wood stove connected to an existing chimney
  • Smoke, odors, or poor draft when an appliance or fireplace is running
  • Cracked or missing flue tiles noted in an earlier inspection report

How We Install a Chimney Liner

The NFPA 211 standard calls for chimneys, fireplaces, and vents to be inspected once a year. It also defines when a more detailed inspection is needed. A change to the system, such as a new appliance or a switch of fuel, calls for a Level 2 inspection. That is usually where liner work starts. If a hidden hazard has to be reached by opening part of the chimney or building, a Level 3 inspection may be needed.

Once we know the condition of the flue, the job typically follows these steps:

  • Inspect the flue, including a camera inspection where access allows
  • Measure the flue and confirm the size and type of the appliances it serves
  • Explain the liner options and what each one involves for your home
  • Clear debris and loose material from the existing flue
  • Install the liner with the proper connections at the top and bottom
  • Fit a cap to keep out rain and animals
  • Check that the appliance drafts correctly through the new liner

Liner Options for Brooklyn Homes

Stainless steel liners are the most common choice for gas and oil boilers and water heaters in rowhouses and brownstones. They can be sized to the appliance and run through tall, narrow, or slightly offset masonry flues. They also hold up to the acidic condensate that gas appliances produce.

Wood-burning fireplaces and stoves have different needs. Depending on the condition of the chimney and how you use it, the right answer might be a stainless liner rated for wood or a repair to the existing masonry flue. We walk you through the reasons for our recommendation so you can make an informed decision.

Scheduling Around Heat Season

New York City's heat season runs from October 1 through May 31. During those months, building owners must keep apartments heated to the city's minimum temperatures. If you own a multi-unit building in Gowanus, it is usually easier to plan liner work for late spring or summer, when a boiler can be off for a short time without affecting tenants. If an inspection during heat season turns up a problem, we can talk through how to proceed.

Besides Gowanus, we install chimney liners in nearby Carroll Gardens, Cobble Hill, Red Hook, Park Slope, and Brooklyn Heights.

More services in Gowanus

Related

What to expect

How a visit goes

  1. Inspect first

    We look at the whole system before suggesting anything, so recommendations are based on what we actually see in your chimney or vents.

  2. Show you the evidence

    We take photos of the flue, crown, damper or ductwork and walk you through them, so you can see the condition for yourself.

  3. Leave the house clean

    We lay down drop cloths, seal off the fireplace opening and use vacuums built for soot and debris, then clean up before we leave.

FAQ

Common questions

Do I need a new chimney liner when converting my boiler from oil to gas?

Often, yes. In New York City, the chimney must be evaluated as part of an oil-to-gas conversion. A new liner is frequently needed because gas exhaust creates acidic condensate that can damage a masonry flue.

How do I know if my chimney liner is damaged?

Common signs include pieces of tile or mortar at the base of the flue, staining or dampness on chimney walls, and poor draft. A professional inspection with a camera is the most reliable way to check.

How long does a chimney liner installation take?

Many residential installations are finished in a day. The exact time depends on the chimney's height, its condition, and how easily we can reach the roof and the appliance connection.

Can a liner be installed in a brownstone with a tall or offset chimney?

In many cases, yes. Stainless steel liners can be run through tall and slightly offset masonry flues. We confirm this during the inspection before recommending any work.

Will I need an inspection before the liner goes in?

Yes. We inspect the flue first so the liner is sized and installed correctly. When a new appliance is added or the fuel changes, the NFPA 211 standard calls for a Level 2 inspection.

Do you serve areas near Gowanus?

Yes. We also install chimney liners in Carroll Gardens, Cobble Hill, Red Hook, Park Slope, and Brooklyn Heights.

Get Your Chimney or Vents Checked

Tell us what you're noticing, whether it's a smoky smell, a stain near the chimney or a dryer that won't dry. We'll inspect, show you photos and give you a written price before any work begins.

Call (447) 312-7370 Request Service